321
by Hawke
The 321 cable gland provides a seal on the outer cable sheath and is intended for use on non-armoured elastomer and plastic insulated cables. The cable gland is Exe and is suitable for installation in Zone 1 (21) and Zone 2 (22) hazardous areas.
by Hawke
The 321 cable gland provides a seal on the outer cable sheath and is intended for use on non-armoured elastomer and plastic insulated cables. The cable gland is Exe and is suitable for installation in Zone 1 (21) and Zone 2 (22) hazardous areas.
- Provides a cable retention seal onto the cables outer sheath.
- When used in Increased Safety applications, this cable gland may be used with braided cable where the braid and the outer sheath pass into the enclosure.
- The braid must then be suitably terminated inside the enclosure.
- Note: Braided cable is classed as unarmoured cable in the EN/IEC 60079 series standards for Exe applications.
Ordering Format [ Gland Type / Size / Male Thread / Female Thread / Material / Options]; Example: 321/ C/ M32/ Brass; Example with alternative seal option: 321 / C / 1 1¼” NPT /Brass / S
Related
Related products
321/R
453/RAC | Group I Mining Gland
by Hawke
The 453/RAC cable gland provides two independent seals on armoured elastomer and plastic insulated cables. The first is a flameproof seal on the inner cable sheath, with an additional IP seal on the outer sheath. This cable gland come with our Reversable Armour Clamp (RAC ring) for use with single wire armour ‘W’, wire braid ‘X’ and steel tape armour ‘Z’ elastomer and plastic insulated cables. The cable gland is dual certified Exd and Exe and is suitable for installation in mining applications.
800 Series
EA231513 (10)
EA303020 (11)
ENY-1
Killark’s sealing fittings offers a wide variety of seal off options for harsh hazardous locations. From small to large hub sizes to vertical and horizontal mounting, EY series can make for any sealing needs significant. Options are available in copper-free aluminum and Duraloy iron with superior electro-statically applied powder coating for the best corrosive resistance.
FXCS-1B1-M
PowerEx
by Hawke
The PowerEx range of connectors have been designed specifically for the extremely demanding requirements of higher power applications. Inserts are available with 1 to 4 contacts with a conductor acceptance range of between 50mm2 and 630mm2 operating up to 780A and 750V as standard. Other voltages available on special request.
