FXCS-1B1-M
Killark SEAL-XM Factory Sealed Series Control Stations provide control solutions in hazardous location areas to supply; START/STOP Motor Functions, LED Pilot Light Indications and more. Utilized in Class 1 Division 1 & 2, Class 1 Zone 1 & 2 areas where Type 3, 7 & 9 protection ratings are required for indoor and outdoor use. cCSAus Certified.
Killark SEAL-XM Factory Sealed Series Control Stations provide control solutions in hazardous location areas to supply; START/STOP Motor Functions, LED Pilot Light Indications and more. Utilized in Class 1 Division 1 & 2, Class 1 Zone 1 & 2 areas where Type 3, 7 & 9 protection ratings are required for indoor and outdoor use. cCSAus Certified.
- Incorporates Factory Sealed Universal contact blocks and GOB3 LED pilot light devices.
- External sealing fittings typically not required, reducing installation time and cost.
- No seal plate between the electrical device and back box allows direct wiring to contact terminals.
- NEMA 3 weatherproof.
- Grounding boss supplied in the splice box.
- Sold as a complete unit.
- Standard finish is a gray epoxy powder baked on for ultimate corrosion resistance.
- More wiring room in back box.
Related products
501/453/UNIV
by Hawke
The 501/453/Universal cable gland provides two independent seals on armoured, elastomer and plastic insulated cables susceptible to damage relating to cold flow. The first is a flameproof diaphragm seal on the inner cable sheath, the second an IP seal on the outer sheath. This cable gland comes with our Reversable Armour Clamp (RAC ring) for use with single wire armour ‘W’, wire braid ‘X’, steel tape armour ‘Z’, elastomer and plastic insulated cables. The cable gland is certified Exdb and Exeb and is suitable for installation in Zone 1 (21) and Zone 2 (22) hazardous areas. Datasheet
FibreEx Connector
by Hawke
Collection Name: FibreEx
In a digital age, one need is clear - the need to process ever-increasing amounts of data at lightning fast speeds. Fibre optics has long catered for this need in commercial applications but, until now, fibre technology has posed serious ignition risk in hazardous areas. The Fibre Ex range combines Hawke’s extensive experience in hazardous environments with specialist knowledge of Fibre Optic technology to safely bring power of Fibre Technology to Ex environments.
FXCS-1A15
InstrumEx
by Hawke
The InstrumEx design allows the live mate and de-mating of signal and low power in hazardous areas safely and quickly. This connector is available in 4, 8 and 9 way configurations , up to 2.5mm contacts and allows for a maximum of 250V, 10A. Made from brass nickel plated or stainless steel material it includes an integral cable glands which not only make the connector smaller it also allows it to be cheaper than its competitors while still maintaining the durability required in hazardous area applications.
PowerEx
by Hawke
The PowerEx range of connectors have been designed specifically for the extremely demanding requirements of higher power applications. Inserts are available with 1 to 4 contacts with a conductor acceptance range of between 50mm2 and 630mm2 operating up to 780A and 750V as standard. Other voltages available on special request.